Filter
Top Products
Page 20
Disassembly/Assembly of the Grill
Exploded Views and Side View of Grill
Burner Placement in slots in back of grill
Heat
Deflector
Grill Box
Drip Pan
U-shaped
burner
Grill
Grate
Stainless
Steel Radiant
Follow the steps below to disassemble the compo-
nents in the grill box.
A. Remove the grill grate, stainless steel radiant and
burner from the grill box.
B. Remove the aluminum rectangular drip pan inside
the grill box as shown below.
C. Install the heat deflector into slots of front panel of
grill box.
D. Insert the end of the burner into the slots at the
back of the grill box. Insert the tab on front of the
burner into slot in the heat deflector.
E. The stainless steel radiant lies on two (2) studs on
each end of the grill can.
F. Place the grill grate, with raised food containment
rail oriented towards the grill box rear.
G. To reassemble the grill, follow these instructions in
reverse order.
CAUTION:
• Use extreme care when placing the grill
components into the grill compartment.
Avoid contacting the ceramic igniter which
could break preventing operation of the
grill.
• The grill must be assembled as shown. The
drip tray heat shields must be in place, and
the burner must be properly positioned
relative to the gas supply. Incorrect assembly
of the grill may result in unsafe or hazardous
conditions during operation.
• Do not leave the grill unattended while in
use.
• Do not use charcoal briquettes or coals of
any kind.
SECTION FOUR: USING THE COOKTOP