Filter
Top Products
9
• Due to the weight, a dolly with soft wheels should
be used to move this unit. The weight must be
supported uniformly across the bottom (See Fig.
6).
• After transporting the professional range by dolly
close to its final location, the range can be tipped
back and supported on the rear legs while the dolly
is carefully removed. THE FLOOR UNDER THE
LEGS SHOULD BE PROTECTED BEFORE
PUSHING THE UNIT INTO POSITION. The
anti-tip device must be installed (Step 4), gas and
electrical connections should be made (Steps 5
and 6), and the backguard installed (Step 7)
before the range is placed in its final position.
• For proper performance, the range must be
level. (It is very important for all products that
have the griddle feature.) The range is leveled by
adjusting the legs with a wrench.
• Replace the kick panel and install the oven door.
To install door, see Page 15. Do not install the
oven door until the range is in its final loca-
tion. It is important that the two (2) screws
retaining the kick panel are secure to prevent
accidental access to hot surfaces.
• Ensure that the burner caps are correctly
seated on the burner bases of the range's
cooktop.
Step 3: Unpacking, Moving and Placing the Range
FIG. 6- Dolly Positioning
Grill / Griddle Tilt Adjustment (Not on all models)
Check the griddle frame adjustment by pouring two tablespoons of water on the back of the griddle
plate. The water should slowly roll into the grease tray. If not, adjust the two screws under the back
of the griddle frame. Start with one half turn CCW of the screws. Further adjustment should be made
by one-quarter turn until water slowly flows into the grease tray.
Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking
the appliance. Never allow children to play with
packaging material.