Filter
Top Products
CARE AND CLEANING
Assembly
WARNING: To avoid injury to persons and damage, always unplug the
appliance and wait for the motor to stop completely, immediately after
operation and before assembling/disassembling or cleaning the appliance.
UNPLUG FROM THE WALL OUTLET.
Before eash use, ensure the Grinding Bowl is empty and all parts are clean.
1. Assemble the Grinding Bowl by lining up the 3 tabs on the Grinding Bowl
with the 3 slots in the top of the Base and turn the Grinding Bowl
clockwise. You will hear a click when the Grinding Bowl is seated
correctly in the Base.
2. Place the Cover onto the Grinding Bowl by aligning the 3 tabs on the
Cover with the 3 slots in the Base. Turn the Cover clockwise.
NOTE: The Coffee Grinder will not operate without the Cover and
Grinding Bowl in the locked position.
Power Cord
To retract the power cord, turn the wheel underneath the Base clockwise. To
unwind the cord, gently pull the plug/power cord straight out from the Base.
Cleaning
1. Remove the Cover by turning it counterclockwise and lifting up.
2. Remove the Grinding Bowl by turning it counterclockwise and lifting up.
3. Wash the Cover and Grinding Bowl in warm soapy water. Rinse and dry.
NOTE: Do not palce any parts of the appliance in the dishwasher.
IMPORTANT: Be careful when wiping out the Grinding Bowl, the
blade is very sharp.
4. Wipe the outside of the appliance with a cloth dampened in warm soapy
water. Ensure that water or any other liquids do not to spill or drip on
the Base. NEVER poke with anything into the Base. If necessary use a
small brush to clean the top of the Base. If water enters the Base,
have the unit checked by an authorized service center. (See warranty)
NOTE: Do not use abrasives.
7
Booklet_DLCG-559_ENG:Salton Booklet 6/11/09 2:07 PM Page 7