Filter
Top Products
23
RH36 & MH36 INSTALLATION & OPERATIONS MANUAL 2M-1189333
Installation & Operations Manual 1189333 Rev 0 (03/07) Page 23
Section 3 - OPERATION
D. 12” x 24” Hot Plate Operation
IMPORTANT: If your hot plate is new you must remove the rust preventative material before turning
the griddle on. Refer to Section 2, Instalaltion, Paragraph E.
1. Turn the termperature controls to the desired temperature and allow 15 minutes of preheat timer
before using the hot plate. the green signal light will remain on while the heating elements are
eneergized and the hit plate is coming up to set temperature.
2. When hot plate is preheated place pots or vessels onto hot plate for cooking.
3. HOT PLATE CLEANING.
a. Wash range with warm soapy water, rinse and wipe dry.
b. Be sure to clean all surfaces around and on the hot plates.
c. Polish with a soft cloth.
E. Round Hot Plate Operation
1. Turn the 3-heat switch to LOW, MEDIUM or HIGH. Allow the hot plate to preheat for 10 minutes
and then place pots or vessels onto hot plate for cooking.
2. Green signal light will remian on until 3-heat switch is turned to the OFF position.
3. ROUND HOT PLATE CLEANING
a. Wash range with warm soapy water, rinse and wipe dry.
b. Be sure to clean all surfaces around and on the hot plates.
c. Polish with a soft dry cloth.
F. Marine Ranges
Marine ranges are provided with a full width grab bar, 6” marine bolt down legs, and oven door latch and sea
rails to prevent movement of pots on range top.
The range top sea rails may have to be repositioned when various size pots or vessels are used.