3
Additional Important Safeguards
1. All users of this appliance must read and understand this
Owner's Manual before operating or cleaning this appliance.
2. The cord to this appliance should be plugged into a 120V AC
electrical outlet only.
3. Do not leave this appliance unattended during use.
4. If this appliance begins to malfunction during use, immediately
turn the Control Dial to the (0) OFF position and unplug the
cord. Do not use or attempt to repair the malfunctioning appli-
ance.
5. If this appliance falls or accidentally becomes immersed in
water, unplug it immediately. Do not reach into the water! Do
not use this appliance after it has fallen into or has become
immersed in water.
6. To reduce the risk of injury to persons or property, never use
this appliance in an unstable position.
7. Do not use this appliance for other than its intended use.
8. Do not use the Blender Container if cracked or chipped.
Polarized Plug
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to
fit into a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a quali-
fied electrician. Do not attempt to modify the plug in any way.
Short Cord Instructions
A Short power-supply cord is provided to reduce the risk resulting
from becoming entangled in or tripping over a longer cord.
Do not use an extension cord with this product.
Electric Power
If the electrical circuit is overloaded with other appliances, your
appliance may not operate properly. It should be operated on a
separate electrical circuit from other appliances.
Plasticizer Warning
CAUTION: To prevent Plasticizers from migrating from the finish of
the counter top or table top or other furniture, place NON-PLASTIC
coasters or placemats between the appliance and the finish of the
counter top or table top.
Failure to do so may cause the finish to darken, permanent
blemishes may occur or stains can appear.
22
RRBL2A/T_IB_15-7-06 7/15/06 8:24 PM Page 5