Filter
Top Products
7.6.
To Boil Water (Cont.)
5. Once the water is actively boiling, promptly unplug the Kettle to
turn it OFF.
6. Before pouring or moving the Kettle, unplug the cord from the
outlet. Using the Handle, carefully lift the Kettle and pour the hot
water. Pour slowly and carefully and keep hands away from the
Lid and Spout.
7. Before next use, make sure the Kettle is unplugged. Allow to cool
completely before cleaning.
NOTE: To interrupt the boiling process, simply unplug from outlet.
CAUTION: DO NOT TOUCH HOT SURFACES.
Boil Dry Protection
A safety thermostat will automatically shut the Kettle OFF if your
Kettle is accidentally plugged in without any water, or if the Kettle is
without sufficient water to cover the Heating Element, or if the Kettle
is allowed to boil dry. Should cycling occur, disconnect the Kettle and
allow to cool before refilling with water.
To Boil A Second Pot Of Water
Unplug the Kettle for 15 minutes and allow to cool.
WARNING: Failure to allow Kettle to cool may cause water to
overheat and spray hot steam when filled. The hot steam can cause
severe burns.
User Maintenance Instructions
This appliance requires little maintenance. It contains no user
serviceable parts. Do not try to repair it yourself. Any servicing
requiring disassembly other than cleaning must be performed by a
qualified appliance repair technician.
To Clean Outside of Kettle
It is recommended that you clean your Kettle regularly.
1. Make sure the Kettle is unplugged and has cooled completely.
2. Clean the outside of the Kettle by wiping with a damp sponge and a
little mild liquid soap, if necessary. Do not use abrasive cleansers,
scouring pads or steel wool as they may scratch the surface.
3. Rinse by wiping with a damp cloth or sponge.
CAUTION: Do Not Immerse the Kettle in Water!
To Remove Mineral Deposits
1. Unplug the Kettle from the outlet and allow to cool before cleaning.
2. Do not immerse the Kettle or any part of the Kettle in water or
any other liquid.
3. There may be deposits of minerals that form inside the Kettle and
flake off during use. Rinse out as needed.
4. Mineral deposits can form a coating over the heating elements
and may cause an "off" flavor in the water and may lengthen
boiling time. In a bowl, mix a diluted solution of one part vinegar
to 4 parts water and pour into Kettle.
5. Plug cord into a grounded 120V AC electrical outlet and allow
water to boil. Unplug Kettle.
6. Pour out hot water and allow to cool. Repeat process with clean
water to rinse.
To Store
Unplug unit and allow to cool. Store in its box or in a cool, dry place.
Never store Kettle while it is still plugged in. Never wrap cord tightly
around the appliance. Do not put any stress on the cord where it
enters the appliance as it may cause the cord to fray and break.
1 Litre Electric Kettle Use and Care Guide