Filter
Top Products
6
Care & Cleaning
Probes
Interior/Exterior
Condenser
1. Remove probes by turning the
circular locking ring which
secures these inside the chiller.
2. Wash/sanitize probes.
NOTE: Probes can be
immersed in water during
cleaning.
3. Allow probes to air dry before
replacing in chiller.
1. Disconnect power supply.
2. Clean both interior and exterior with a soft cloth as you
would any other stainless steel surface.
3. Do not...
• Use cleansers containing chlorine.
• Clean with anything abrasive.
• Hose off the blast chiller.
Cleaning the condenser is critical to insuring proper
performance and long compresor life.
1. Disconnect power supply.
2. Lift-up or remove louvers covering coil location:
• RBC50: Front/Left (see gure 1)
• RBC100: Bottom/Left (see gure 2)
• RBC200: Front/Top
3. Wipe coil ns clear of any dust or debris present using
a dry shop cloth or pot brush.
4. Replace louvers.
5. Restore power.
g. 2
g. 1