Filter
Top Products
-5-
VI. a - SERVICE INFORMATION:
Before calling for service, please check the following:
Is the electrical cord plugged in?
Is the fuse OK or circuit breaker on?
Is the power switch “ON”?
If after checking the above items and the unit is still not
operating properly, please contact an authorized Traulsen
service agent. A complete list of authorized service agents
was provided along with your Traulsen unit. If you cannot
locate this, you may also obtain the name of a service agent
from the SERVICE & PARTS button of our website: www.
traulsen.com.
If service is not satisfactory, please contact our in-house
service department at:
Traulsen
4401 Blue Mound Road
Fort Worth, TX 76106
(800) 825-8220
Traulsen reserves the right to change specications or dis-
continue models without notice.
VI. b - SPARE PARTS:
Spare or replacement parts may be obtained through a parts
supplier or one of our authorized service agents. A complete
list of authorized service agents
is posted on the on our company’s ofcial website @ www.
traulsen.com under the SERVICE & PARTS button.
VI. c - WARRANTY REGISTRATION:
For your convenience, the warranties on your new Traulsen
unit may be registered with us on-line at www.traulsen.com,
under the SERVICE & PARTS button.
V. CARE & MAINTENANCE (continued)
V. c - REPLACING THE GASKETS:
To remove the gasket to be replaced, grasp it rm-
ly by one corner and pull it out. Before attempting to in-
stall a new gasket, both the unit and the gasket itself
must be at room temperature. Insert the four corners
rst by using a rubber mallet (or hammer with a block of
wood). After the corners are properly inserted, work your
way towards the center from both ends by gently hit-
ting with a mallet until the gasket is completely seated in
place (see gure below for proper gasket placement).
NOTE: The gasket may appear too large, but if it is in-
stalled as indicated above it will slip into place.
V. d - CLEANING THE EXTERIOR:
Exterior stainless steel should be cleaned with warm water,
mild soap and a soft cloth. Apply with a dampened cloth and
wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the surface.
Do NOT use cleansers containing chlorine, this may pro-
mote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, whenmopping the
oor around the unit.
For stubborn odor spills, use baking soda and water (mixed
to a 1 TBSP baking soda to 1 pint water ratio).
V. e - CLEANING THE INTERIOR:
For cleaning both stainless steel and anodized aluminum
interiors, the use of baking soda as described in section “V.
d” is recommended. Use on breaker strips as well as door
gaskets. All interior ttings are removable without tools to
facilitate cleaning.
VI. OTHER