Filter
Top Products
End of Day (continued)
5 TRAULSEN TD048HT & TD078HT TRAINING GUIDE 6
Routine Maintenance
Care of the Display Canopy (required as needed)
Cleaning the Condenser (required approx. every 90-days)
1. Disconnect power supply.
2. Remove the screws securing canopy brackets (see
g. 1).
3. Lift curved canopy section(s) towards front, out of
mounting bar bracket, and up and away from the
cabinet (see g. 2).
NOTE
On 78” units the two canopy sections are
connected by a plastic H-Channel.
4. Lift out canopy side pieces.
5. Wash all canopy parts in hot, soapy water.
6. Allow to air dry and wipe away any water spots using
a clean, dry cloth.
7. Reassemble by reversing steps 1 thru 4.
Cleaning the condenser is critical to insuring proper
performance and long compressor life.
1. Disconnect power supply.
2. Open the compressor access door.
3. Vacuum or brush coil ns clear of any dust or debris
present.
4. Close the compressor access door.
5. Restore power.
1. Throughly clean fan post using alcohol or mineral
spirits and a clean, lint-free cloth.
2. Clean the bearing inside of the fan blade assembly
using a cotton swap moistened with alcohol or
mineral spirits (see g. 1).
3. Place a few drops of the lubricant supplied by
Traulsen into the fan blade assembly rear.
4. Replace the fan blade assembly on the post.
III. Cleaning the Fan Blade(s) (required after each use)
1. Open the compressor access door.
2. Locate drain hose over a oor drain or large bucket
(see g. 1).
3. Open drain valve by turning clockwise.
4. Spray out the display well and sanitize thoroughly.
Allow all water to run out the drain.
4. Close the drain valve by turning counter-clockwise.
Close the compressor access door.
5. Wipe out the refrigerated area behind the doors
using a non-abrasive, non-clorinated, stainless steel
safe cleanser. Leave the door(s) open until next
use.
II. Cleaning the Cabinet (required after each use)
WARNING!
Spraying water inside the refrigerated area behind the
doors may cause equipment damage and/or injury.
g. 1
g. 1
IV. Completion
1. Reassemble cabinet by reversing steps 1 thru 9 on page 4.
NOTE: Leave door(s) open until next use and power is restored.
WARNING!
Use of ammonia or ammonia containing cleaners, such
as windex, will blur and/or craze the plexiglass canopy.
g. 2
g. 1
g. 2
g. 1
g. 2