Filter
Top Products
CLEANING THE GRILL DEFLECTOR,
GRILL PAN, GRILL PAN GRID, SERVERY
AND OVEN SHELVES
All removable parts can be washed in the
dishwasher.
The grill pan and grill deflector can be cleaned using
a soap impregnated steel wool pad. The grill pan
grid, servery and oven shelves should be cleaned
using hot soapy water. Soaking first in soapy water
will make cleaning easier .
CLEANING INSIDE THE OVEN/GRILL
COMPARTMENTS
The Stayclean surfaces inside the main oven
(2560S) and top and main ovens (2590S) should not
be cleaned manually. See "Care of Stayclean
Surfaces".
The vitreous enamel oven base and grill
compartment (2560S only) can be cleaned using
normal oven cleaners or aerosol oven cleaners with
care. Ensure that the manufacturers instructions are
followed and that all parts are well rinsed afterwards.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements as this may cause damage.
CARE OF STAYCLEAN SURFACES
Stayclean surfaces destroy splashes of food and fats
when the oven temperature is raised to around
220°C.
It is a good idea to run the oven for an hour or two
per week to ensure continued good performance
from the Stayclean finish.
HINTS AND TIPS
Manual cleaning of Stayclean IS NOT
recommended. Damage will occur if oven
sprays or abrasives of any kind are used.
Slight discolouration and polishing of the
Stayclean surface may occur in time. This
does not affect the Stayclean properties in
any way.
A good time to allow the oven to run on is after
the weekly roast. After removing the roast, turn
the oven up to 220°C and allow to run for an hour
or so. It is important NOT to allow a build-up of
soilage as this can prevent the Stayclean from
working.
Follow the recommendations below to keep oven
soilage to a minimum.
Cook at the recommended temperatures. Higher
temperatures during roasting will increase
soilage. Try cooking at lower temperatures for an
increased length of time, you will save energy
and often the joint is more tender.
Use minimal, if any, extra oil or fat when roasting
meat, potatoes only require brushing with fat
before cooking. Extra fat in the oven during
roasting will increase splashing and soilage.
It is NOT necessary to add water to the meat tin
when roasting. The water and the fat juices from
the joint create excessive splattering during
cooking - even at normal temperatures, as well
as causing condensation.
Covering joints during cooking will also prevent
splashing onto the interior surfaces. Removing
the covering for the last 20-30 minutes will allow
extra browning if required. Some large joints and
turkeys especially benefit by this method of
cooking, allowing the joint to cook through before
the outside is over-browned.
2828