Filter
Top Products
29
To move the appliance, open the grill door.
Raise the appliance off its front feet by lifting
it from inside the oven. Pull the appliance
forward. When you replace the appliance
push it back to the stop and make sure there
is the same gap at each rear corner.
For your safety
Do not
try to disconnect the appliance from
the gas supply if the supply pipe does not
have a bayonet connection, as described in
the installation instructions. If this is the case
contact the person who installed the
appliance.
Location of appliance
This appliance must not be installed in a
bed-sitting room of volume less than 20m
3
or
in a bathroom, shower room or garage. It is
essential that the appliance is positioned as
Fig.1. The appliance must be a minimum of
20mm from the rear wall (note that this
dimension is provided by the inlet elbow).
Shelves, wall cabinets and cooker hoods
must not be fitted closer than 500mm to the
top of the grill canopy or within 100mm of the
sides of the grill. Curtains must not be fitted
immediately behind the appliance or within
200mm of the sides of the grill. If fitted next
to or between two base units a minimum
space of 1mm must be left between each
unit and the sides of the appliance. The
hotplate must be set to a minimum of 7mm
above the adjacent units (note that the
levelling feet fitted to the appliance will
achieve a nominal height to hotplate level of
907mm -5+13mm. Base units not meeting
the above conditions must be a minimum of
100mm away from the hotplate.
Note:
- L.P.G. cookers MUST NOT be
installed below ground level i.e. in a
basement or aboard any boat, yacht or other
vessel.
Fig.1