27
CLEANING INSIDE THE OVEN AND
GRILL COMPARTMENTS
The sides and back panel of the main oven are
coated with special Stayclean coating.
The Stayclean surfaces inside the oven should not
be cleaned manually. See below ‘Care of Stayclean
Surfaces’.
The vitreous enamel in the top oven, grill
compartment and fan oven base can be cleaned
using normal oven cleaners or aerosol oven cleaners
with care. Ensure that the manufactures instructions
are followed and that all parts are well rinsed
afterwards.
Aerosol cleaners must not be used on the
Stayclean surfaces and must not come into
contact with elements or the door seal as this
may cause damage.
For advice on how the keep the Stayclean surfaces
in good condition see ‘Care of Stayclean Surfaces’.
CARE OF STAYCLEAN SURFACES
The Stayclean surfaces destroy splashes of food and
fats when the oven temperature is raised to around
220°c.
It is a good idea to run the oven for an hour or two
per week to ensure continued good performance
from the Stayclean finish.
HINTS AND TIPS
· Manual cleaning of the Stayclean surfaces IS
NOT recommended. Damage will occur if
abrasives or aerosol sprays of any kind are used.
· Slight discolouration and polishing of the
Stayclean surfaces may occur in time. This does
not affect the Stayclean properties in any way.
· A good time to allow the oven to run on is after
the weekly roast. After removing the roast, turn
the oven up to 220°C and allow to run for an hour
or so.
· It is important not to allow a build-up of soilage as
this can prevent the Stayclean surfaces from
working.
· Follow the recommendations below to keep oven
soilage to a minimum.
· Cook at the recommended temperatures. Higher
temperatures during roasting will increase
soilage. Try cooking at lower temperatures for
an increased length of time, you will save energy
and often the joint is more tender.
· Use minimal, if any, extra oil or fat when roasting
meat, potatoes only require brushing with fat
before cooking. Extra fat in the oven during
roasting will increase splashing and soilage.
· It is NOT necessary to add water to a meat tin
when roasting. The water and the fat juices from
the joint create excessive splattering during
cooking - even at normal temperatures, as well
as causing condensation.
· Covering joints during cooking will also prevent
splashing onto the interior surfaces. Removing
the covering for the last 20-30 minutes will allow
extra browning if required. Some large joints and
turkeys especially benefit by this method of
cooking, allowing the joint to cook through before
the outside is over-browned.