Filter
Top Products
Tricity Bendix Service Force
8
WARNING: THIS COOKER MUST BE EARTHED
RATING PLATE
Record the model, product and serial numbers on
the back cover of this instruction book from the
rating plate. This is situated on the lower front
frame of the cooker and can be seen upon opening
themainovendoor.
The cooker must be protected by a suitably rated
fuse or circuit breaker. The rating of the cooker is
given on the rating plate.
Do not remove the rating plate from the cooker
as this may invalidate the guarantee.
INSTALLATION
If your cooker has been damaged in transit,
contact your supplier immediately. DO NOT
attempt to install it.
Your cooker left the factory fully packaged to
protect it from damage. If it is delivered without
packaging and damage has occurred, the
manufacturer cannot accept responsibility. Contact
you supplier for advice.
Once the packaging has been removed the cooker
should only be moved by hand. DO NOT use a
sack barrow or any other aid to lift the cooker as
damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles. The
cable must have conductors of sufficiently high
cross-sectional area to prevent overheating and
deterioration.
Six square millimetres (6.00mm
2
2
)
)
i
i
s
s
t
t
h
h
e
e
r
r
e
e
c
c
o
o
m
m
m
m
e
e
n
n
d
d
e
e
d
d
c
c
r
r
o
o
s
s
s
s
-
-
s
s
e
e
c
c
t
t
i
i
o
o
n
n
a
a
r
r
e
e
a
a
.
.
The cable must be routed away from potentially hot
areas marked by X in the diagram below.
To move the cooker, open the main oven door, and
lift the cooker by holding inside the top of the
compartment.
This is a type Y cooker which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
Ensure that the cooker is standing level.
Side walls which are above hob level should be
protected by heat resistant non-combustible
material and MUST NOT be nearer than 40mm to
the hob side.
A nominal air gap of 2mm all around the cooker is
required to enable the cooker to be moved into
position.
Always ensure an air gap is maintained at hotplate
level. Tiles or other forms of deep wall covering
should not obscure this gap.
INTRODUCTION
Air gap
R
EAR VIEW