Tricity Bendix SIG 233/1 Range User Manual


 
10
Using the Hob
The Hob Burners
The symbol on the control panel shows which
burner is operated by the knob. (See control
panel).
Off
Maximum level
Minimum level
Use the maximum level for boiling and the
minimum for simmering.
Always choose positions between the minimum
and maximum, never between maximum and off.
Ignition of the burners
Push the knob and turn it left to the “large flame“
symbol.
At the same time, push the electronic ignition
knob (see fig). Keep it pushed until the gas
ignites (1 spark / second).
Release the knob and check that the burner
has ignited.
Upon ignition, adjust the flame as required.
OR
Power Cut
Push the corresponding knob in completely
and turn it left to the “large flame“ symbol and
ignite with a match.
Release the knob and check that the burner
has ignited.
Upon ignition, adjust the flame as required.
If for any reason the flame should extinguish turn
off the relevant control knob, leave for at least
one minute and then re-ignite.
If after a few attempts the burner does not ignite,
check that the burner ring and its cap are
correctly positioned.
Turning off the burners
Turn the control knob clockwise to mark «
».
Do not put anything on the hob that is
liable to melt.
Selecting the Correct burner
Above every knob there is a symbol for the
corresponding burner.
For good cooking results, always choose pans,
which correctly fit to the diameter of the burner
used (see figs). Choose thick, flat bottom pots.
We recommend the flame is lowered as soon as
the liquid starts boiling.
For a correct ignition always keep the burner ring
and the spark plugs clean.
Good use
B
a
d
use
(
Power waste
)