Filter
Top Products
Before using your coee machine for the rst time:
Open the lid. Fill the tank with water up to the MAX (12 cup) level. Use the coee
pot or a measuring jug to accurately pour in the water. Close the lid.
DO NOT OVERFILL.
Place the pot centrally on the hotplate. Ensure that the hole in the lid of the pot
engages with the spring valve in the machine to ensure an even ow of liquid.
Press the ON/AUTO/OFF button to start. The Indicator light glows red.
After all the water has run into the pot:
Press the ON/AUTO/OFF button twice. The Indicator ashes a steady Blue. This
indicates that the machine has been turned o. After a few seconds the Blue light
will extinguish.
Discard the contents of the pot. Allow 5 minutes for the unit to cool down. Carry
out two more full operating cycles using fresh cold water to thoroughly clean the
machine.
Points to remember:
Disposable lters if used should be specially made for coee makers. Use size 4
(10-12 cups).
Make sure you use coee specially ground for lter use.
NOTE: You do not need to set the time to brew coee for instant use, but if
you do not set the time you will not be able to reliably use the Programmed
Auto Start feature
PREPARING COFFEE
Place the pot centrally on the hotplate. Ensure that the hole in the lid engages with
the spring valve in the machine.
Open the lid of the coee maker. Remove the lter. Spoon in the required amount
of coee grains into the lter - typically 6-7 g. per cup, or to taste. You may use a
disposable lter if you prefer.
The measuring scale on the water tank indicates the number of cups your coee
maker will brew. Fill the water tank with fresh cold water to the level correspond-
ing to the number of cups required. Follow the markings on the side of the water
tank or use the coee pot to measure the water. DO NOT OVERFILL.
Insert the lter into the lter compartment. Close the lid.
Press the ON/AUTO/OFF button to start the process. The indicator light will glow
red and the coee starts brewing..
When all the coee has run into the coee pot: Wait for one minute until all the
coee has nished running into the pot. The pot can then be removed.
If you wish to keep the coee in the pot warm: Place the pot on the hotplate.
After the brewing cycle has ended the indicator light will glow Red and the hotplate
stays on for 2 hours unless you switch it o.
DO NOT touch the hotplate for at least 20 minutes after the ON/AUTO/OFF light has
extinguished.
If you want to brew more coee: Switch the machine o. Allow the machine to
cool down before proceeding.
To stop the brewing cycle at any time: Press the ON/AUTO/OFF button twice.
The Indicator ashes a steady Blue. This indicates that the machine has been turned
o. After a few seconds the Blue light will extinguish.
Operation
Getting Started
5