Filter
Top Products
............ www.truemfg.com ............
............ www.truemfg.com ............
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
10
10
10
10
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS
Step 6
A. The compressor is ready to operate. Plug in the
cooler.
B. Temperature control set at No. 4 position gives
freezers an approximate temperature of 20°F - 25°F.
Allow unit to function several hours, completely
cooling cabinet before changing the control setting.
C. Excessive tampering with the control could lead
to service difficulties. Should it ever become
necessary to replace temperature control, be sure it
is ordered from your True dealer or recommended
service agent.
D. Good air flow in your True unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four inches
of the evaporator housing. Refrigerated air off the
coil must circulate down the back wall.
NOTE
If the unit is disconnected or shut off, wait five
minutes before starting again.
RECOMMENDATION
Before loading product we recommend you run
your True unit empty for two to three days. This
allows you to be sure electrical wiring and
installation are correct and no shipping damage
has occurred. Remember, our factory warranty
does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial
number for your cooler. If at any time during the
life of your cooler, a part is needed, you may
obtain this part by furnishing the model number
and serial number to the company from whom
you purchased the cooler. Call Toll-Free: (800)-
424-TRUE (Direct to Parts Department). (800)-
325-6152 (U.S.A. & Canada only) or call: (636)-
240-2400.
LIGHT SWITCH LOCATION:
GDIM models will have the light switch located on the
right side on the ceiling inside the unit. Most instances
the switch is located next to the temperature control.
STARTUP