Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
10 10
MAINTENANCE, CARE & CLEANING
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be followed, including the following
TOOLS REQUIRED:
• Phillips screwdriver
• Stiff bristle brush
• Vacuum
Step 1
Disconnect power to unit. Take off lower grill
assembly. Remove phillips screws at the bottom
of the grill. Holding grill at the bottom gently pull
out and down as shown. (see illustration 1).
Step 2
Clean off accumulated dirt from condensing coil
with a stiff bristle brush and clean fan blade
NOTE
It may be necessary to use CO
2 or compressed air to
blow off any dust or debris from condenser coil. Use
a vacuum to clean up any debris.
Warning
Do not bend or disrupt the refrigeration lines when
cleaning the condenser coil. True is not responsible
for damage done to the condensing unit and
refrigeration lines.
Step 3
Remove bolts anchoring compressor assembly
to frame rails and carefully slide out. (tube
connections are flexible)
Step 4
Lift W.R. Board cover above fan at plastic plugs
and carefully clean condenser coil and fan blade.
Step 5
After brushing condenser coil vacuum dirt from
coil, and interior floor
Step 6
Carefully slide compressor assembly back into
position and replace bolts.
Step 7
Reinstall grill assembly onto unit. Connect unit to
power and check to see if fan blade is turning.
®
Illustration 1