Filter
Top Products
02/2005 11 www.U-LineService.com
15R and 15WC Models
Installation of the 15R/15WC
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to
entangle the electrical cord.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
surface should be approximately 1/8" below the
countertop.
Grille Installation
1. Locate and remove the grille screw from the cabinet,
using a standard blade screwdriver (or a 1/4"
nutdriver). See Figure 23
.
.
2. Remove the control knob by pulling it away from the
cabinet.
3. Identify the grille screw hole on the grille itself. It is
located toward the top of the middle recessed section
of the grille.
4. Place the two hook-hinges (located on the rear bottom
side of the grille) onto the front lip of the unit base.
Swing the grille up into position, aligning the grille
screw hole on the grille to the grille screw hole on the
cabinet. See
Figure 24
.
5. Insert the screw. Do not overtighten.
6. Reinstall control knob.
Glass Shelf Installation
(15R Refrigerator Only)
1. Carefully remove the glass shelves from the packaging.
2. Slide the shelves onto
lower sets of ribs, making
sure the decorative
graphics are on the
underside of the shelves.
White edge strips go
toward the rear and silver
edge strips go toward the
front. See
Figure 25
.
8 Install the Unit
Grille Screw
Figure 23
Hook-Hinges
Hook-Hinge
Unit Base
Front Lip
Grille
Figure 24
Figure 25