02/2005 5 www.U-LineService.com
™
2075R Refrigerator and 2075RF Refrigerator/Freezer
Product Dimensions
Please note that the unit has adjustable feet that can add
one additional inch to height during leveling or to match
adjacent cabinets (see Figure 32 on Page 13).
Door Swing/Clearances Information
Black and White units have a zero clearance for the door
to open 90° (see Figure 3). Stainless Steel models require
a minimum of 2-1/8" door clearance to accommodate the
handle if the unit is installed next to a wall or similar type
of structure.
Reversing the Door
(Black and White Units Only)
All U-Line units (except
Stainless Steel models) may
be left- or right-hand
opening. The door opening is
easily reversed by moving the
hinge hardware to the
opposite side. The top hinge
hardware will be used on the
bottom of the other side and
the bottom hinge hardware
will be used on the top of the
other side (see Figure 4).
To reverse the door:
1.
Remove top hinge screw
pin from door (7/64" Allen
wrench or Phillips
screwdriver, depending on your unit’s construction) (see
Figure 5
).
Remove
door by tilting forward and lifting
off bottom hinge pin.
2.
Remove plastic screw plugs (3 each, top and bottom)
from new hinge location. Do not discard (see
Figure 6
).
3. Remove top hinge (3 screws), reinstall hinge screw pin,
and remount on opposite side BOTTOM (see
Figure 7
).
34-1/8"
25-3/8"
Including
Handle
23-1/4"
Including
Handle
23-15/16"
Black and White
23-15/16"
Stainless Steel
34-1/8"
Figure 2
1/4" Min.
Wall Wall
2-1/8" Min.
90°
Door Swing
Black and White
Stainless Steel
90°
Door Swing
21"
25-1/2"
21"
25-1/2"
Figure 3
WARMER
17
4
35
26
COLDER
Figure 4
Screw Plugs
Figure 5 Figure 6