Filter
Top Products
3-56
Section 3 - Service and Repair
REPLACING EVAPORATOR FAN MOTOR
- CO2175DWR
1. Disconnect unit from power source.
2. Remove two screws
(Figure 58)
holding evaporator fan cover to
evaporator cover.
3. Unplug fan connection.
4. Remove two nuts
and two washers holding the fan to the fan
bracket.
5. Replace with new fan.
6. Plug in the fan connection, making sure the fan wires are tucked
behind the fan bracket.
7. Reinstall evaporator cover.
8. Reinstall unit and test.
9. Reinstall fan bracket to liner, making sure the fan wires are tucked
behind the fan bracket.
10. Reinstall unit and test.
To access evaporator or drain:
1. Disconnect unit from power source.
2. Remove two screws
(Figure 58)
holding evaporator cover to
drain pan.
3. Remove two screws
holding evaporator to drain pan.
4. Remove two screws holding fan bracket to drain pan.
5. Unplug fan connection.
6. Reinstall parts in reverse order.
7. Reinstall unit and test.
Figure 59. CO2175DWR
ULIN_0372_A
Evaporator fan
cover screws
Washers
Nuts
Fan bracket
screws
Evaporator
cover screws
Evaporator
cover screws
Evaporator to
drain pan screws