U-Line 2175BEVOL2 Refrigerator User Manual


 
03/2008 15 www.U-LineService.com
2175BEV/2175BEVOL2 Beverage Center
2. Place the unit into the area where it will be installed.
Check the door, sides and top for a proper fit. Also test
the make sure the door opens and closes freely.
3. Remove grille and place mark on the floor at the front
of the unit. Also place a mark on the floor in the center
of the unit (
Figure 27
).
Figure 27
4. Remove the unit. Using a square, extend a centerline
20-1/4” toward the back wall (
Figure 28
). At the back
of the centerline, mark a line that measures 11-1/16” to
the left and right. This line services as the back edge for
the Anti-Tip brackets and its furthest points mark the
outer edge of each bracket.
Note: Instructions are shown for built-in installation. Use
same dimensions for free-standing installation.
Figure 28
5. Place the Anti-Tip brackets on the floor against the line
drawn for the outer edge. Mark spots for the screw
holes (
Figure 29
).
6. Use a 1/8” drill to make two starter holes and fasten the
Anti-Tip brackets to the floor using the screws provided.
Figure 29
CAUTION
Other hardware is required for floors made of
materials other than wood.
7. Place the unit back into position, making sure the feet
engage the Anti-Tip brackets properly. Check the
alignment of the lines made on the floor in step 3 with
the position of the front feet to ensure proper
positioning.
SINGLE UNIT INSTALLATION
1. Remove the two screws from the opposite side of the
hinge assembly using a Phillips screwdriver (Figure
30).
Right–handed units shown, Left–handed units are mirrored
Figure 30
2. Place bracket (part # 14154) over holes and attach to
unit with two screws removed in step 1 using a Phillips
screwdriver. Tighten screws fully.
3. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
4. Secure bracket into adjoining surface.
Marks on floor
20
-
1/4"
Back
Wall
Line Marks
Back
of Unit
Front
of Unit
11
-
1/16" 11
-
1/16"
Centerline
Marks
on Floor
Back
Wall
Back
of Unit
Drill Holes and
Mount Anti-Tip
Brackets to Floor
Front
of Unit