U-Line 2175BEVOL2 Refrigerator User Manual


 
2175BEVS/2175BEVOL2 Beverage Center
www.U-LineService.com 8 03/2008
Final finish-only application:
1. Remove all screws securing wood trim to interior
components, and remove the trim.
2. Lightly scruff sand the wood trim with 280 or finer grit
sandpaper.
3. Remove sanding dust with a clean, dry cloth.
4. The factory-applied seal is compatible with virtually all
finishes. A low odor, water clean up, quick-drying finish
such as Minwax
®
Polycrylic
®
Protective Finish is
recommended (Minwax
®
Polycrylic
®
is an ultra fast-
drying water-based finish). Apply a thin coat of a clear,
protective finish, following the container label
directions.
5. Lightly sand and reapply if desired.
6. Allow the final coat to dry for 24 hours before
reinstalling the trim to the cabinet interior components.
Reversing the Door
(All U-Line units (except Stainless Steel models) may be
left- or right-hand opening. The door opening is easily
reversed by moving the hinge hardware to the opposite
side. The top hinge hardware will be used on the bottom
of the other side and the bottom hinge hardware will be
used on the top of the other side (see Figure 7).
To reverse the door:
1. Using a Phllips screwdriver, remove top hinge screw
pin from door (Figure 7). Remove door by tilting
forward and lifting off bottom hinge pin.
Figure 7
2.
Remove metal hinge plugs (3 each, top and bottom)
from new hinge location. Do not discard (
Figure 8
).
Figure 8
3. Remove top hinge (3 screws), reinstall hinge screw pin,
and remount on opposite side BOTTOM (
Figure 9
).
Figure 9
4. Remove the two door closer inserts from the existing
bottom hinge and install as shown on the new bottom
hinge (
Figure 10
).
Figure 10
5. Remove existing bottom hinge (3 screws) and remount
on opposite side TOP. Remove hinge screw pin.
6. Remove the plastic hole plug from the top of the door
to allow the pivot pin to be inserted in the new
location. Install the plug into the vacated hole on the
opposite side.
ULIN_0015_A
Hinge plugs
hinge screw
pin
hinge screws
ULIN_0003_A
door closer inserts