Filter
Top Products
CO2175FF, 2175RF 17
Glass Shelf Removal/Installation
Remove the shelves as follows:
Figure 26
1. Pull shelf out about 6" (Figure 26) until back of shelf
clears the “hump” on the right hand side.
2. Tilt right hand edge of shelf up.
3. Remove shelf from unit by pulling out.
Insert the shelves as follows:
1. Insert shelf at an angle, approximately 15-20°, over the
rib in the side of the unit where you want to place the
shelf. The shelf must be started into the unit at an
angle to clear the door.
2. Continue to slide the shelf into the unit at an angle
until it clears the door.
3. Lower the shelf and push it in completely.
Light Bulb Replacement
To replace the light bulb in your U-Line unit:
Figure 27
1. Grasp the edges of the light housing lens
(Figure 27, 1) opposite the exposed tab and gently
push the lens toward the tab (Figure 27, 2).
2. Pull the edge of the lens down
(Figure 27, 1)
and
swing it out of the light housing.
IMPORTANTIMPORTANT
ALWAYS use a genuine U-Line replacement bulb (P/N
31317) in the light housing. Use of any other bulb
within the housing will generate excessive heat,
causing damage to the light housing and cabinet
interior, and will compromise the precise
temperature control of your unit.
3. Replace the bulb only with a genuine U-Line P/N 31317
replacement.
4. Replace the lens by first inserting the tab side back into
the housing at a slight angle. While gently pushing the
lens towards the tab end, push the free end up into the
housing, and release when you will hear a snap/click.
ULIN_0213_A
1
2
ULIN_0001_A