www.U-LineService.com 12 02/2005
75R, 75WC and 75BEV Models
4. Place the two hook-hinges (located on the rear bottom
side of the grille) onto the front lip of the unit base.
Swing the grille up into position, aligning the grille
screw hole on the grille to the grille screw hole on the
cabinet. See
Figure 22
.
.
5. Insert the screw. Do not overtighten.
6. Reinstall control knob.
Glass Shelf Installation
(75R Refrigerator and 75BEV Beverage Centers Only)
1. Carefully remove the glass shelves from the packaging.
2. Slide the shelves onto lower sets of ribs, making sure
the decorative graphics are on the underside of the
shelves. While edge strips go toward the rear and silver
edge strips (75R Only) go toward the front. See
Figure 23
.
Initial Start-Up
The unit is shipped with the control preset to a mid-point
setting between 4 and 5. Assure that setting was not
altered in shipment. No other adjustments should be
necessary at this time. For information about Adjusting
the Temperature Control, see the User Manual.
Start-Up Troubleshooting
Problem
Q:
Unit does not appear to turn on when plugged in.
Solution
A:
Make sure outlet has power (circuit breaker has not
tripped).
Problem
Q:
The light stays on when the door is closed.
Solution
A:
Make sure on/off switch is turned OFF. Check to see that
light switch actuator bracket is contacting the light switch
properly.
IMPORTANT
See the User Manual’s Troubleshooting Guide for more
solutions.
Hook-Hinge
Hook-Hinge
Unit Base
Front Lip
Grille
Figure 22
Figure 23
9 Start-Up for the First Time