Filter
Top Products
10
Cleaning And Maintenance
Periodic cleaning and proper maintenance will ensure efficiency and
top performance.
Interior - The Wine racks may be removed by removing the security
tabs at the rear of each rack if desired. Clean the interior of the cabinet
with mild soap and water and rinse with clear water. The lock tabs at the
rear of the wine racks must be properly secured with the snap rivets.
The upright rear brace should not be touching the evaporator on the
rear wall of the Wine Captain.
Avoid the use of solvent cleaning agents, abrasives, and cleaners.
Exterior - The exterior may be cleaned with mild cleaners or mild
soap and water.
Glass Door - The glass door may be cleaned using a glass cleaner or
mild soap and water. Avoid use of abrasive cleaners.
Condenser - The condenser coil, located behind the front grille,
should be cleaned three to four times per year. Using a brush or vacuum
cleaner remove dirt, lint and other accumulations from the condenser
coil.
The condenser fins are sharp. DO NOT run hands or fingers
over condenser fins.
To remove and replace the grille to obtain access to the condenser
fins please follow this procedure:
1. Using a standard blade screwdriver, remove the screw (located toward
the middle of the grille).
2. Remove the cabinet knob.
3. Grasp the grille in both hands and pull up and forward.
4. Clean the condenser coil using a brush or vacuum cleaner.
5. To install the grille place the two hook hinges (located on the back
bottom side of the grille) on the front lip of the unit’s base. Swing
the grille up into position, aligning the grille and cabinet’s screws.
6. Insert the grille screw and tighten being careful not to overtighten.
7. Install the control knob.
!
WARNING
41739 Origins WC Body.qxd 10/22/03 1:40 PM Page 10