Filter
Top Products
14 BI95, BI98, SP18
5. Remove screws on opposite side of cabinet
(Figure 19)
.
Note that there may be a nut behind one or both
screws on either side.
Figure 20
6. Install hinge on opposite side, bottom of cabinet
(Figure 20)
. Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
Figure 21
7. Relocate plastic spacer/bushing
(Figure 21)
on bottom
of door to opposite side, and place door on bottom
hinge pin. Clean out bushing hole in door bottom with
a screwdriver if necessary.
Figure 22
8. Remove plastic hole plug
(Figure 22)
from door handle
and relocate on opposite side.
9. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge.
Figure 23
10.Remove three plastic screw plugs
(Figure 23)
from
hinge holes, top of cabinet, opposite side. Be careful
not to scratch cabinet.
11.Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 24
12.Fasten upper hinge to unit (three screws)
(Figure 24)
.
Partially tighten screws.
13.Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
14.Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit on opposite side.
15.Replace the grille.
ULIN_0123 _
A
1
ULIN_0109_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A