Filter
Top Products
www.U-LineService.com 10 09/2008
SS1095
MARINE SERIES
Checking Door Alignment
The unit’s door is aligned at the factory before shipment.
However, its alignment could have been disturbed during
shipment or during door panel installation.
IMPORTANT
Properly aligned, the door’s gasket should be firmly
in contact with the cabinet all the way around the
door (no gaps). Carefully examine the door’s gasket
to assure that it is firmly in contact with the
cabinet. Also make sure the door gasket is not
pinched on the hinge side of the door.
1. Loosen (do not remove) top (Figure 19) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.
CAUTION
Plumbing installation must observe all state and local
codes. All water connections MUST BE made by a licensed/
qualified plumbing contractor. Failure to follow
recommendations and instructions may result in damage
and/or harm.
WARNING
To prevent accidental electrocution, make certain
that the floor surfaces surrounding the unit are
dry whenever power is removed from, or applied
to, the unit.
Water Supply Connection
When connecting the water supply, follow these
guidelines:
• Review the local plumbing codes before you install the
unit.
• Connect to the cold water supply.
• The water pressure should be between 20 and 120 psi.
• Install a shut-off valve in the 1/4 inch OD water supply
line.
• Connect sufficient tubing to the unit so that tubing
may be looped, allowing the unit to be removed for
cleaning and servicing (see Figure 23). However, make
certain that the tubing is not pinched or damaged
during installation.
• If using the flexible water supply kit, follow the
instructions included with the kit.
To connect to water supply:
1. With a standard blade screwdriver or 1/4” nut driver,
remove the grille screw (Figure 20). Remove the
grille.
2. Install the 1/4 inch OD copper water line from the main
water source.
5 Adjust Door
ULIN_1044_A
Hinge screws
Figure 19
6 Prepare Plumbing
Model ULN-SS1095FD
Model ULN-SS1095NF/FC
ULIN_1045_A