Filter
Top Products
U-Line 3000 Series Maintenance 10
Leveling
IMPORTANTIMPORTANT
Unit must be level for proper door operation.
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side
edge as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise
or lower each corner of the unit (2) as necessary.
3. To rotate rear leveler legs remove grille. See Removing and
Installing Grille on page
10
.
4. Using the provided 6mm T bar allen wrench, rotate the 2
adjustment screws as shown below.
5. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
Removing and Installing Grille
WARNING
• Disconnect electrical power to the unit before
removing the grille.
• Edges of sheet metal may be sharp.
Removing the grille.
1. Disconnect power to unit.
2. Using the included 7/64" Allen wrench, loosen, but do not
remove both grille lock screws. See below.
3. Gently pull grille away from unit until it stops.
4. Push Grill rails towards the center of the unit to lift rails off lock
screws.
5. Pull grille free from unit.
Installing the grille.
1. Align slots in grille rail with screw heads in base of unit
2. Push grille rails towards the center of the unit and set rails over
screw head.
3. Slide grille into position. Using included 7/64" Allen wrench
tighten grille lock screws.
6 3000 Series Maintenance
1
2
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Grille Mounting
Screws
Grille Rail