Filter
Top Products
6
®
CAST IRON STOVE AND BURNER SYSTEM
106828
For more information, visit www.desatech.com
SBVBN(C) AND SBVBP(C)
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
Continued
Figure 11 - Attaching Stove Door
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Bolt
Shoulder
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw
Door
Figure 12 - Catch Bolt and Door Claw
Orientation
9. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Fig-
ure 11 and Figure 9 on page 5). Use an
adjustable wrench or a 12mm socket
to fasten step bolt. Tighten step bolt
until snug. Make sure door moves
freely.
Figure 10 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Washers
10. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
threaded hole on stove body (see Fig-
ure 9, page 5). Use an adjustable
wrench or a 12mm socket. The catch
bolt has two hex nuts attached to it (see
Figure 12). The top nut is a bolt stop
and the bottom nut is for door leveling
adjustment.
11. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
12. Carefully lift stove back up on its four
attached legs.
13. Remove 2 bolts from bottom of stove
and discard. Remove bolt from the top
of the stove to remove the front panel
assembly (see Figure 13).
14. Lay the front panel assembly face down
on a protected surface. Remove the two
screws that hold the front plate onto the
front surround plate (see Figure 14).
Save these screws.
15. Remove the seven screws and washers
that hold the screen onto the front sur-
round plate. Discard these screws,
washers, and screen. They are for vent-
free use only (see Figure 14).
16. Replace the two screws from step 14
to reassemble the front plate and the
front surround plate. Set this assembly
aside until burner system has been in-
stalled, logs have been placed inside of
burner system, and glass door to burner
system insert has been replaced.
Figure 13 - Removing Front Assembly
Front
Assembly
Bolt
Stove
Body
Figure 14 - Removing Screen from Front
Assembly
Screws
Front Surround
Plate
Front Plate
Screen
Screw with
Washer