Filter
Top Products
19
Fig. 5.2
Fig. 5.5
A
B
Fig. 5.4
Fig. 5.1
S
F
C
T
BURNERS AND GRIDS
✓ These parts can be removed and
cleaned with appropriate products.
✓ After cleaning, the burners and their
flame distributors must be well dried
and correctly replaced.
✓ It is very important to check that the
burner flame distributor and the cap
has been correctly positioned - failure
to do so can cause serious problems.
✓
Check that the probe next to each
burner is always clean to ensure cor-
rect operation of the safety valves.
✓ Keep the electrode clean so that the
sparks always strike.
✓ Note: To avoid damage to the elec-
tric ignition do not use it when the
burners are not in place.
CORRECT REPLACEMENT
OF THE SEMI-RAPID
BURNERS
It is very important to check that the
burner flame spreader “F” and the cap
“C” have been correctly positioned (see
figs. 5.1 and 5.2 ).
Failure to do so can cause serious
problems.
In appliances with electric ignition, check
that the electrode “S” (figs. 5.1-5.3) is
always clean to ensure trouble-free
sparking.
Check that the probe “T” (figs. 5.1-5.3)
next to each burner is always clean to
ensure correct operation of the safety
valves.
Both the probe and ignition plug must
be very carefully cleaned.
CORRECT POSITION OF
TRIPLE RING BURNERS
The triple ring burner must be correctly
positioned (see fig. 5.3); the burner rib
must be fitted in their housing as shown
by the arrow.
The burner correctly positioned must not
rotate (fig. 5.4).
Then position the cap A and the ring B
(fig. 5.4 - 5.5).
Fig. 5.3
S
T