Filter
Top Products
21
SETTING THE BURNER MINIMUM
When switching from one type of gas to another, the minimum flow rate must also be
correct: the flame should not go out even when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions below:
Semirapid and triple ring burners
– Light the burner
– Set the gas valve to position
– Remove the knob
– With a thin screwdriver turn the screw "F" until adjustment is correct (fig. 2.7).
Inside crown of DUAL burner
– Light the DUAL burner
– Set the gas valve to
position
– Remove the knob
– Using a screwdriver turn the screw "H" until the correct setting is obtained (fig. 2.8).
Outside crowns of DUAL burner
– Light the DUAL burner
– Set the gas valve to
position
– Remove the knob
– Using a screwdriver turn the screw "G" until the correct setting is obtained (fig. 2.8).
For LP/PROPANE gas, tighten the adjustment screws completely.
Fig. 2.8
G
H
regulation
screw
Fig. 2.7