Filter
Top Products
10
LIGHT BULB REPLACEMENT
This unit uses a 15-watt appliance bulb with an intermediate base located
inside the light shield. The light shield is on the back of the unit and is
held in place by the use of three screws. Remove the three screws and
light shield to remove the light bulb. DO NOT replace the bulb with a
bulb higher than 15 watts.
EENNEERRGGYY SSAAVVIINNGG TTIIPPSS
•Reduce door openings.
•Close the door as soon as you can.
•Keep the condenser coils on bottom of the refrigerated beverage center clean. (See “Cleaning and Maintenance”.)
•Adjust the temperature control to a warmer setting when practical.
•Do not put hot foods in the refrigerated beverage center.
•Install unit away from the stove or other heat sources.
INTERIOR LIGHT
The interior light allows you to view the unit’s contents. When the switch is in the “OFF” position, the light will come on only
when the door is opened. In the “ON” position, the light remains on continuously. NOTE: Outdoor units do not have a light
switch.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect the power cord when changing the light bulb
may result in electrical shock.
Light
Shield
Screws
OPERATING INSTRUCTIONS
SSeettttiinngg tthhee CCoonnttrroollss
The total available temperature range of the indoor unit is from 39 - 42
0
F (4.0
-
- 5.6
0
C) to 54 - 56
0
F (12 - 13
0
C). The total
available temperature range of the outdoor unit is from 33 - 35
0
F (0.5
-
- 1.1
0
C) to 54 - 56
0
F (12 - 13
0
C). The higher the number
selected, the cooler temperature within the unit. Initially set the control knob midway between the numbers. Allow at least 48
hours for the unit to stabilize before making any adjustments to the initial setting.
FOR OUTDOOR UNITS - it is recommended that in temperatures above 110
o
F(43
o
C) and below 40
o
F (4.4
o
C) the unit be shut
off. The normal operating range for the unit is between 60
o
F (15.6
o
C) and 100
o
F (37.7
o
C).
GGeenneerraall TTiippss aanndd SSuuggggeessttiioonnss
•After making a temperature adjustment, allow 24 hours for your refrigerated beverage center to reach a new temperature
setting.
•The motor will start and stop often. It must do this to maintain the temperature setting.
•Unplug the refrigerated beverage center before working on anything with the electrical system.
•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grill and/or the light
fixture switch can occur.