Filter
Top Products
Product Controls
11
Features: Cycles
Product Controls
10
Features: Cycles
Wash Cycles
POTS/PANS
Heavily soiled pots, pans and casserole dishes. Long heated prewash
loosens up encrusted food. High temperature main wash and final rinse.
NORMAL WASH
Normally soiled dishes. Energy-usage label is based on this cycle.
LIGHT/CHINA
Lightly soiled items, china and crystal. Lower temperatures for cleaning
delicate items.
RINSE/HOLD
All dishware. Short rinse with no heat.
Options
HI TEMP WASH
Increases the temperature, adding heat, time and water for improved cleaning
performance. Available only with POTS/PANS and NORMAL WASH.
Note:
Periods of soaking will occur to aid in removal of baked on soils
SANITIZED 155˚F RINSE
Raises water temperature to 155˚F in the final rinse. Adds heat and time to
the cycle. This high temperature rinse sanitizes your dishes and glassware in
accordance with NSF/ANSI STANDARD 184 for Residential Dishwashers.
Certified for residential dishwashers and not intended for licensed food
establishments. Available only with POTS/PANS and NORMAL WASH.
DELAY START
Lets you delay running the dishwasher for up to 4 hours. To set
“DELAY START”, select the desired wash cycle and option(s). Press the
“DELAY START” button once and the number “2” will light, indicating
a two hour delay. If you desire a longer delay, continue pressing the
“DELAY START” button to a 4 hour delay. The corresponding number
on the button will light. Once you have set the desired delay time,
press the “START” button and close the door. “DELAY START” is not
available with the Rinse/Hold cycle.
AUDIBLE SOUND SIGNAL
A single beep will occur when you select cycles, options and press the
“START” key. If the “START” button is not pressed or if the door is not
closed within 4 seconds of pressing the “START” button, 3 short beeps
will occur. The end-of-cycle signal consists of 2 long beeps and
activates 30 minutes after the last drain, when the condensate dry
portion of the cycle is completed. For all other error messages and to
deselect the audible sound signal, see the Troubleshooting/ Fault
Codes section.
ILLUMINATION OF BUTTONS
Option, Cycle and Start buttons will only illuminate after they are
selected. The "SANITIZED" indicator will illuminate when the cycle has
been completed. If your dishwasher did not properly sanitize your
dishes, the indicator light will not illuminate. This can happen if the
cycle is interrupted or the water could not be heated to the required
temperatures. The "SANITIZED" indicator light goes off after you have
opened and closed the door or if you press and hold the
START/RESUME button.
OptionsOptionsCyclesCycles324 Model3