Viking F20021C Food Warmer User Manual


  Open as PDF
of 6
 
1110
SSeerrvviiccee IInnffoorrmmaattiioonn
If your warming drawer should fail to operate:
1. Have you read and followed the instructions provided?
2. Is the circuit breaker open, or is a fuse blown?
If service is required:
1. Call your dealer or authorized service agency. The name of the
authorized service agency can be obtained from the dealer or
distributor in your area.
2. Have the following information readily available:
a. Model number
b. Serial number
c. Date purchased
d. Name of dealer from whom purchased
3. Clearly describe the problem that you are having.
If you are unable to obtain the name of an authorized service agency, or if you
continue to have service problems, contact Viking Range Corporation at (662)
451-4133 or write to:
VVIIKKIINNGG RRAANNGGEE CCOORRPPOORRAATTIIOONN
PPRREEFFEERRRREEDD SSEERRVVIICCEE
111 Front Street
Greenwood, Mississippi (MS) 38930 USA
Record the information indicated below. You will need it if service is ever
required. The model and serial number for your warming drawer are located
on the left side of the drawer housing on an identification label. Pull out drawer
for access.
Model Number Serial Number
Date of Purchase Date Installed
Dealer’s Name
Address
If service requires installation of parts, use only authorized parts to ensure
protection under the warranty.
PPLLEEAASSEE RREETTAAIINN TTHHIISS MMAANNUUAALL FFOORR FFUUTTUURREE RREEFFEERREENNCCEE
MMaatteerriiaall CClleeaanniinngg PPrroodduuccttss DDiirreeccttiioonnss
Stainless Steel / Mild cleaners Sponge with cloth, then rinse
Enamels with clear water and wipe
dry. Satisfactory for use on
all finishes.
Plastic (Control Knob) Soap and water Pull off knob. Wash, but do
not soak. Rinse with water,
dry and replace on control.
CCLLEEAANNIINNGG CCHHAARRTT
CCAAUUTTIIOONN
DDoo nnoott uussee aannyy cclleeaanniinngg aaggeenntt wwiitthh cchhlloorriinnee oorr cchhlloorriinnee ccoommppoouunnddss
oonn ssttaaiinnlleessss sstteeeell ffiinniisshh..
Chlorine and chlorine compounds are
corrosive to stainless steel.
When cleaning hard water spots and scales, use a vinegar and water
solution. Swab or wipe with cloth. Rinse with clear water and dry. If the
spots remain after using vinegar and water, a soft, non-abrasive cleaner
can be used. Apply with damp sponge or cloth. Satisfactory for use on all
finishes if rubbing is light. Always rub in the direction of the polish lines.
 previous