Filter
Top Products
11
OPERATING INSTRUCTIONS
SSeettttiinngg tthhee CCoonnttrroollss
The total available temperature range of the indoor unit is from 39 - 42
0
F (4.0
-
- 5.6
0
C) to 54 - 56
0
F (12 - 13
0
C). The total
available temperature range of the outdoor unit is from 33 - 35
0
F (0.5
-
- 1.1
0
C) to 54 - 56
0
F (12 - 13
0
C). The higher the number
selected, the cooler the temperature within the unit. As with any refrigerated beverage center, there is a slight temperature
variance at different locations within the cabinet. For example, the coolest area will be in the rear of the shelf above the glass
shelf. The area on the top shelf will be 3 - 7
0
F warmer. The area in the front will be 1 - 5
0
F warmer than the area in the rear of
the shelves. The wine section area of the refrigerated beverage center will be warmer than any other section.
To start your refrigerated beverage center, use a screwdriver to turn the control clockwise to the middle thermostat setting.
Once the refrigerated beverage center is loaded allow at least 48 hours for the unit to stabilize before making any adjustments
to the initial setting.
FOR OUTDOOR UNITS - it is recommended that in temperatures above 110
o
F(43.3
o
C) and below 40
o
F (4.4
o
C) the unit be shut
off. The normal operating range for the unit is between 60
o
F (15.6
o
C) and 100
o
F (37.8
o
C).
GGeenneerraall TTiippss aanndd SSuuggggeessttiioonnss
•After making a temperture adjustment, allow 24 hours for your refrigerated beverage center to reach a new temperature
setting.
•The motor will start and stop often. It must do this to maintain the temperature setting.
•Unplug the refrigerated beverage center before working on anything with the electrical system.
•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grill and/or the light
fixture switch can occur.
LIGHT ASSEMBLY REPLACEMENT
NOTE: Please contact your Viking Range Corporation
parts distributor or dealer to order new light assembly.
To replace the light, first disconnect the refrigerated
beverage center’s power cord. Next, remove both
the green ground wire screw located on the left of the
light assembly and the other screw located on the
right of the light assembly with a 5-16” hex head
screwdriver. (See drawing). Unplug the light unit and
remove complete light assembly.
To install the new light assembly, screw in the green
ground wire screw and the screw located on the right
with a 5/16” hex head screwdriver and plug the light
unit in.
Plug
Hex head
screw
Light
assembly
Green
ground wire
Hex head
screw
INTERIOR LIGHT
The interior light allows you to view your refrigerated beverage center contents. When the switch is in the “OFF” position, the
light will come on only when the door is opened. In the “ON” position, the light remains on continuously. NOTE: Outdoor
units do not have a light switch.
WARNING
Failure to disconnect the power cord when changing the light assembly may result in
electrical shock.