Filter
Top Products
Product Care
55
DO NOT touch bulb with bare hands. Clean off any signs of oil
from the bulb and handle with a soft cloth.
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main fuse or circuit
breaker before replacing bulb.
DO NOT touch bulb with bare hands. Clean off any signs of oil from
the bulb and handle with a soft cloth.
1
1
4
2
3
1. Unsnap glass light cover
using a screwdriver in the
access groove.
2. Firmly grasp light bulb and
pull out.
3. Replace with halogen bulb
using volt and wattage
requirements listed on glass
cover.
4. Replace the light cover by
snapping glass cover onto
metal box.
5. Reconnect power at the main
fuse or circuit breaker.
54
Product Care
To start the Self-Clean cycle:
1.Close the door completely.
2.Turn the oven selector knob clockwise to the “SELF CLEAN” mode.
3.Turn the temperature control knob to the clean setting stop. At this
time, the clean indicator light will come on. Within 30 seconds the
automatic door latch engages and the oven indicator light comes
on. The oven indicator light will remain on until the oven reaches the
self-clean temperature and will then cycle on and off during the self-
clean cycle. When the oven reaches the elevated temperature
needed for self-clean, the door lock indicator light comes on.
4.The door lock indicator light will remain on until the self-clean is
completed or interrupted and the oven temperature drops to a safe
temperature. A complete cycle is approximately 2-1/2 hours with an
additional 30 minutes needed for the oven to cool down enough for
the door latch to disengage.
Note: A fan noise will be heard during the self-clean cycle and will
continue to run for the 2-1/2 hour duration of the self-clean cycle.
Note: On griddle model ranges, the griddle/simmer plate will not
function during the self-clean cycle.
5.When the cycle is completed, turn both the oven selector and
temperature control knob to the “OFF” position. When the oven has
completely cooled, open door and remove any ash from the oven
surfaces with a damp cloth.
To stop the Self-Clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the
temperature control knob and the oven function selector knob to
“OFF”. When the oven temperature drops to a safe temperature, the
automatic door latch will release and the oven door can be opened.
When the oven has completely cooled, remove any ash from the
oven surfaces with a damp sponge or cloth.
Replacing Oven Lights
Self-Clean Cycle
(VDR Dual Fuel models)
WARNING
WARNING