Filter
Top Products
12 13
6. Locate blue float valve on/off lever. Move lever up about
half way to shut water off.
7. Locate drain plug and pull the drain plug out to drain the
reservoir and evaporator. When draining is complete, return
the plug to its original position.
8. Mix a solution of cleaner with water: 1.25 ounces of cleaner
with 16 oz of warm water.
12. The auger motor alone will be operating for 10 minutes,
after that the compressor will start and in about 5-8
minutes the machine will start to make ice. The Time to
Clean light will now glow steady until the clean cycle is
complete.
Caution: Keep fingers away from moving parts.
After ice making starts, continuously add scale remover solution
to the reservoir to keep it about half full.
When all 16 oz of the solution is used, move the float valve
lever down to the On position.
Care and Cleaning (con’t)
Care and Cleaning (con’t)
Note: Take care not to spill any scale remover on any nearby
surface. Immediately wipe any spill with baking soda and water.
9. Fill the 16 oz squirt bottle with the diluted scale remover.
10. Fill the reservoir with the scale remover solution using
squirt bottle or other container. That will be about 8 ounces
or half a squirt bottle.
WARNING
Ice machine scale remover contains
acids. Acids can cause burns.
If concentrated cleaner comes in
contact with skin, flush with water. if
swallowed, DO NOT induce vomiting.
Give large amounts of water or milk.
Call Physician immediately. Keep out
of the reach of children.
ON/OFF
ICE
MAKING
CHECK
WATER
TIME TO
CLEAN
CLEAN
RESET
11. Press and HOLD both the Clean-Reset and On/Off buttons
for 5 seconds. The Time to Clean light will blink on and off.
ON/OFF
ICE
MAKING
CHECK
WATER
TIME TO
CLEAN
CLEAN
RESET
PRESS
BOTH