Filter
Top Products
Service Information
If service is required, call your dealer or authorized service agency.
The name of the authorized service agency can be obtained from the
dealer or distributor in your area.
Have the following information readily available.
• Model number
• Serial number
• Date purchased
• Name of dealer from whom purchased
Clearly describe the problem that you are having. If you are unable to
obtain the name of an authorized service agency, or if you continue
to have service problems, contact Viking Range Corporation at
1-888-VIKING1 (845-4641), or write to:
VIKING RANGE CORPORATION
PREFERRED SERVICE
1803 Hwy 82W
Greenwood, Mississippi 38930 USA
Range – The serial number and model number
for your appliance can be found by
opening the door and looking under
the control panel.
Record the following information indicated below.
You will need it if service is ever required.
Model no._____________________ Serial no. ________________________
Date of purchase _______________ Date installed ___________________
Dealer’s name __________________________________________________
Address ________________________________________________________
_______________________________________________________________
If service requires installation of parts, use only authorized parts to
insure protection under the warranty.
Keep this manual for future reference.
Product Care
46 47
Troubleshooting
Problem
Possible Cause and/or Remedy
Range will not function.
Range is not connected to electrical power:
Have electrician check power circuit breaker,
wiring, and fuses.
Oven does not operate in
self-clean.
Door is not shut tight enough for automatic
door latch to lock.
Oven is not clean after self-
clean cycle.
Temperature control knob not rotated all the
way past clean until it stops.
Broil does not work.
Temperature control knob is rotated too far
past broil position.
Door will not open.
Oven is still in self-clean mode. If oven is
hot, door latch will release when safe
temperature is reached.
Oven light will not work.
Light bulb is burned out.
Range is not connected to power.
Igniters will not work.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Igniters sparking but no
flame ignition.
Gas supply valve is in “OFF” position.
Gas supply is interrupted.
Igniters sparking
continuously after flame
ignition.
Power supply is not grounded.
Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ignites but flame is
large, distorted, or yellow.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.