Filter
Top Products
3
CASTERS
Your beverage dispenser is equipped with four casters. the
front two casters can be locked.
For built-in applications, the four casters can be removed by
removing the nut located inside the dispenser cabinet and
then pulling the threaded caster spindle through the base of
the unit.
CABINET CUTOUT - FREESTANDING MODELS
A 24” (61.0 cm)*
B 35 9/16” (90.3 cm)**
C 24” (61.0cm)
D 24 3/4” (62.9 cm)
*24” width for cabinet only. 24 1/4” (61.6
cm) needed for cabinet and door width
clearance if door is recessed between
cabinets.
**35 9/16” (90.3 cm) height is without casters
mounted to unit. 39 3/4” (101.0cm)
needed for height clearance with casters.
If removing the casters is necessary for installation, the unit
should be raised off the ground. This should be done with an
approved material.
(Consult local building codes for approved material.)
LEVEL UNIT
1. After placing unit in position, check to make certain the unit is level side to side and front to back.
2. Accurate leveling is essential for proper operation.
Lock and Unlock
C
B
A
D