~ Always assemble with rubber seal in place
~ To remove blade assembly from container, turn CLOCKWISE.
~ To attach blade assembly to container turn COUNTER-CLOCKWISE.
USING YOUR SMOOTHEE-BAR™ BLENDER
BEFORE FIRST USE: Wash all parts, except motor base, in warm, soapy water. Never
immerse motor base in water, as this will damage the motor.
SEVEN SIMPLE STEPS TO SUMPTUOUS SMOOTHEES!
1. Add liquids first
2. Add fruits & soft foods next
3. If adding any ice, add last and add sparingly.
4. Start on LO setting, about 30 seconds.
5. Move Smoothee-Stick from side to side as needed to keep ingredients moving
6. Move to HI setting, until smooth.
7. Serve the Smoothee
ACACACACACACACACACA 5 CACACACACACACACACACA
ASSEMBLING YOUR SMOOTHEE-BAR™ BLENDER
1. Place the motor base on a flat, level surface. Never place container onto base while motor
is running.
2. To mount the smoothee-container, line up the faucet to the arrow marking on the motor
base that says “Align Here”.
3. Then turn the smoothee-container clockwise. There is an arrow marking on the motor
base to indicate this clockwise direction.
4. Turn until smoothee-container stops, and will not turn further. Now the faucet should be
pointing forward.
5. Plug the blender into a 120 volt 60 Hz AC only outlet.
6. The container lid must always be in place whenever motor is running.
7. The smoothee-stick may be removed to add additional ingredients while blending. Note: If
you are not using the smoothee-stick, there is a separate small cap cover that fits over the
hole in the lid.
Your blender is now ready for use.
GETTING FAMILIAR WITH YOUR
SMOOTHEE-BAR™ BLENDER
ACACACACACACACACACA 4 CACACACACACACACACACA
Smoothee-Stick
Lid
Lid Cap
Smoothee-Container
Smoothee-Spout
Off-Lo-Hi Buttons
Pulse Button
Motor Base
(Never immerse in water)
Drip Tray
Smoothee-Container
Blade Assembly Rubber Gasket
Blade Assembly
Container Handle
5785_Booklet.qxd 1/8/04 1:37 PM Page 4