Filter
Top Products
REVERSAL OF DOOR SWING
The door of the cooler could be opened either from the left or right side.
The cooler is installed to open from the left side.
To reverse, please do as follows:
1. Disconnect the power, take out all of the beverages and lay the
cooler back on the ground.
2. Remove the upper hinge cover.
3. Unscrew the screws on the upper hinge board.
4. Remove the door and the upper hinge from the lower hinge axis.
5. Remove the upper hinge from the door. Install the upper hinge on
the other side of the door.
6. Unscrew the two screws for the door handle. Remove the door
handle and install it on the other side of the door.
7. Unscrew the two screws on the lower hinge. Remove the right
lower hinge and left lower hinge and install them on the other side.
8. Remove the two upper hinge blocks on the other side of the cooler.
9. Reinstall the door.
10. Install the upper hinge board and upper hinge cover.
Note: Please remember, do not power up the unit for 48 hours, to allow
the coolants to settle inside the compressor.
Additional instructions for door handle installation:
1. Gently pull away the door gasket in the area where the handle is to
be installed. The gasket is easily displaced by hand; no tools are
necessary.
2. Use a Phillips head screwdriver to remove/install screws securing
door handle. (Do not over tighten screws as this will cause damage
to the handle.)
3. If needed, use a flat head screwdriver to remove the 2 decorative
plugs from the front of the door or the plugs at the top of the door
where the hinge is located, if they are located on the side you wish
the handle to be installed on. Save the plugs for future use.
4. Replace the door gasket to its original position. Insert plugs into
open door holes if desired.
8
WWW.VINOTEMP.COM