Filter
Top Products
11
1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1
info@vinotemp.com
Installing Stainless Steel Handle:
• Pull away the door gasket in the area where the handle is to be
installed. The gasket is easily removed by hand, no tools are
necessary.
• Using a Flat head screwdriver remove the two (2) pre-installed
decorative plugs from the backside of the door. Save the decorative
plugs for future use.
• Insert the two (2) Phillips head screws with the lock washers and
flat washers through the gasket side of the door frame until the
screws pass through the door frame. Follow the sequence shown in
the figure.
• Align the handle with the screws installed in the above step.
Tighten the screws using a Phillips head screwdriver until the
handles secure tightly against the door frame. (Do NOT over
tighten as this will cause damage to the handle assembly).
• Replace the door gasket to its original position.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer