Filter
Top Products
9
1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1
info@vinotemp.com
INSTALLATION INSTRUCTIONS
Before Using Your Appliance:
• Remove the exterior and interior packaging.
• Before connecting the appliance to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of
a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door.
Installation of Your Appliance:
• Use two or more people to move and install appliance. Failure to do
so can result in back or other injury.
• Place your wine cooler on a floor that is strong enough to support it
when it is fully loaded.
• Choose a well-ventilated area with temperatures above 50°F and
below 90°F.
• The appliances are designed to be for built-in, recessed or free
standing installation.
• For free standing installation, 1 inch of space for the back and ¼
inch for each side of the unit is needed. This allows the proper air
circulation to cool the compressor and condenser.
• Even for built-in installation, must keep space on each side and at
the top. If you plan to use the units in a built-in application please
follow the requirements shown below:
Cabinet Opening Dimensions (minimum)
Width 24”
Depth 25”
Height 33”
• The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes.
• Make certain that the pipes are not pinched, kinked or damaged
during installation. Check for leaks after connection.