Filter
Top Products
REVERSAL OF DOOR SWING
The door of the wine cellar could be opened either from the left or right
side. The wine cellar is installed to open from the left side.
To reverse, please do as follows:
1. Disconnect the power, take out all the wines and lay the wine cellar
back on the ground.
2. Remove the screw on the right downward hinge cover and remove
the right downward hinge cover.
3. Remove the screw on the right downward hinge and remove the right
downward hinge.
4. Remove the screw on the door support and remove the cover of door
support.
5. Remove the fixing screw on the door support and remove the door
support.
6. At this point, you will be able to remove the door.
7. Remove the fixing screw on the door handle, then remove the handle
and fix it on the right of the door.
8. Tear off the PVC cover of the top control panel.
9. Remove the five screws and take off the plastic panel.
10. Remove the upper door axis, axis jacket and install them to the left,
then tighten the screw.
11. Install the plastic panel and tighten the screws.
12. Recover the new PVC cover packed in the accessory kit.
13. Install the door.
14. Install the left downward hinge (in the accessory kit) and install the
right downward hinge cover.
15. Install the door support on the place of the right downward hinge and
then affix the cover.
16. You now have the door fully installed on your desired side.
Note: Please do not power up the unit for 48 hours to allow the coolants
to settle inside the compressor.
10
WWW.VINOTEMP.COM