Filter
Top Products
Additional instructions for door handle installation:
1. Gently pull away the door gasket in the area where the handle is to
be installed. The gasket is easily displaced by hand; no tools are
necessary.
2. Use a Phillips head screwdriver to remove/install screws securing
door handle. (Do not over tighten screws as this will cause damage
to the handle.)
3. If needed, use a flat head screwdriver to remove the 2 decorative
plugs from the front of the door or the plugs at the top of the door
where the hinge is located, if they are located on the side you wish
the handle to be installed on. Save the plugs for future use.
4. Replace the door gasket to its original position. Insert plugs into
open door holes if desired.
CLEANING AND CARE
x Always unplug the wine cellar before cleaning.
x Do not use benzene, scrubbing brushes or chemical cleaners as these
will damage the unit.
x Use only a mild, nonabrasive cleanser to clean the exterior of the
cabinet.
x Clean the stainless steel door and handle by wiping with a warm water
and baking soda solution. The solution should be about 2 tablespoons
of baking soda to a quart of water.
x Wash the racks with a mild detergent solution.
x Always dry all parts with a clean, dry cloth before plugging the wine
cellar back into the receptacle.
MOVING YOUR WINE CELLAR
x Always unplug the wine cellar before moving.
x Remove all bottles before moving the wine cellar.
x Securely tape down all loose items (shelves) inside your appliance.
x Turn the leveling legs up to the base to avoid damage.
x Tape the door shut.
x Be sure the wine cellar stays in the upright position during
transportation
x Protect the outside of appliance with a blanket or similar item when
moving as needed.
11
17631 South Susana Road, Rancho Dominguez, California 90221
info@vinotemp.com