Filter
Top Products
10
17621 South Susanna Road,
Rancho Dominguez, California 90221
info@vinotemp.com - Fax 310.886.3310
800.777.8466
REVERSAL OF DOOR SWING
The door of the wine cellar could be opened either from the left or right side.
The wine cellar, factory is installed from the left side.
If you want to reverse the open direction of door, please do as follows:
1. Disconnect the power, take out all the wines and lay the wine cellar back
on the ground. Please remember when finished reversing the door, not to
power up the unit for 24 hours to allow the coolants to settle in the
compressor.
2. Remove top hinge cover. Use the special screw driver to remove the three
screws on the top hinge, then lift up the door to take the door off.
3. Remove the support wheel on the left bracket.
4. Unscrew the two screws and remove the grill.
5. Use the special screw driver to unscrew the six screws on the right
downward door axis and left bracket.
5. Install the right bracket and left downward door axis.
6. Remove the door handle, and fix it on the right of the door, please do as
following:
a. Pull the gasket with hand, then you can see four screws (Two screws
are on the upper of door, and other two screws are on the lower of
door).
b. Remove these fixing four screws on the door handle.
c. Remove the handle, and fix it on the other side of the door. Screw
four screws on the other side of door. Then embed the gasket to the
door.
8. Reinstall the door.
9. Install the top hinge on the other side.
10. Screw back in place the top hinge cover, grill and screw covers.
11. Install the support wheel on the right bracket.
12. You now have the door fully installed on your desired side.