Vinotemp VT - IMSW Ice Maker User Manual


 
9
17621 South Susana Road, Rancho Dominguez, California 90221
info@vinotemp.com
TROUBLESHOOTING GUIDE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before contacting Vinotemp.
PROBLEM POSSIBLE CAUSE
Ice maker does not power
on
Not plugged in.
A tripped circuit breaker or a blown fuse.
Ice maker control switch is set in “OFF” position.
Ice maker is on but not
producing ice
Airflow to front grill is blocked
Ice maker arm was set in the “OFF” position
Water supply is turned off
Water line is crimped; water is not reaching unit
Ice maker has excessive frost build up
Compressor turns on and
off frequently
Room temperature is warmer than normal.
Appliance door is open too often.
Door is not closed completely.
Door gasket does not seal properly.
Ice maker does not have adequate ventilation. Check
to ensure that the grill is unobstructed and condenser
coils are clean.
Excessive vibrations Check to assure that the ice maker is level. Adjust the
leveling legs as needed.
Ice maker seems to make
too much noise
A rattling noise may come from the flow of the
refrigerant; this is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your appliance.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
Ice maker is not level.
Door will not close properly
Ice maker is not leveled.
Door was reversed and not properly installed.
Door gasket is dirty.
The ice bucket is out of proper position.
Ice cubes are melted
together
Ice maker door is opened too often