Filter
Top Products
NOTE: Switches will become sticky from use. Use a wet cloth or sponge to flush and
clean in the groove around the water-shielded switches. You may also lightly spray
the surface around the switches with an all purpose cleaner (such as Cinch
®
or 409
®
)
and work the switches back and forth a few times to loosen any dried residue under
switch. Leaving switches sticky will damage or burn out the switches.
4
BarBoss
®
MP &
Drink Machine MP Model
ON/OFF switch. Located on the front of the
machine below the switch panel, controls the
power to the machine. With the machine plugged
in, switch the machine to ON to ready the
machine for blending. Shut OFF power switch
at night or whenever the machine will be left
unattended.
START TIMER switch. This is a lighted switch.
When light is lit power is ON. Depress START
TIMER switch to activate timer setting and again
to stop midcycle.
During operation, you may interrupt timer by
pressing ST
ART/STOP switch.
TIMER DIAL. Allows user to select a number
of timed settings. Increments on timer are
approximate seconds. Timer is activated
only
when the power switch is ON. Blender will shut
off automatically at the end of the pre-set time.
PULSE switch. Pulse button can only be used
when the power switch is ON. The PULSE
switch can be used to quickly refresh product
in the container by depressing the switch and
holding down as long as needed.
Note on Timers: Stop mid cycle with
START/STOP switch, not the
ON/OFF switch. If the ON/OFF
switch was used, wait 30 seconds for
power to recycle and the timer to
reset before resuming operation.
S
T
A
R
T
/S
T
O
P
TI
M
E
R
#
1
#
2
#
3
#
4
#
5
PULSE
M
ax
OFF
ON