Filter
Top Products
6
BarBoss
®
MP & Drink Machine MP Instructions
1. Set the container on the motor base by aligning it over the centering pad anchored to
the base. (Motor must be completely stopped before positioning container). Containers
are not to be used for hard, dry materials. Avoid running your machine with the container
empty.
2. Place liquids and soft foods in the container first, solid items and ice last. Prepare
food by cutting or breaking into 1-3 inch (3-8 cm) pieces. Frozen fruit should be as small
as practical.
3. Always use lid when blending. If blending hot ingredients, the lid must be securely in
place. When processing hot liquids, DO NOT use a non-latching lid.
4. Press ON/OFF switch to ON. Activate the timer by selecting the desired setting
on the dial and then depressing the START/STOP TIMER switch on the left.
NOTE:
Each setting on the dial (#1 - #5 and MAX Blend) is an increase in time and
speed. Your own testing will determine what setting will work best for your drinks.
4a. If mixture stops circulating, you have likely trapped an air bubble. Either insert the
tamper through the lid while blending, or stop the motor remove the container from
the base and stir or scrape the mixture from the sides of container into the center
using a rubber spatula to press any air bubbles away from the blades. Replace the
lid and continue blending.
Note:
START/STOP TIMER switch on your machine is lit when power is ON. Avoid
moveable parts. The timer stops working if machine is overloaded on low speed.
Reset the machine by turning power OFF for 15 seconds.
Warning: If you detect a change in the sound of the machine or if a hard or
foreign object comes into contact with the blades, do not serve the drink.
Inspect your blade assembly for loose, nicked or missing parts. If parts are
loose, missing, or nicked replace with new blade assembly. (See page 8.)
4b. To prevent possible splashing, lightly rest your hand on the lid while turning the
machine on (except when processing hot liquids).
4c. Due to the blending speed of the machine, processing times are greatly reduced
over standard machines. Until you become accustomed to the speed, watch your
mixture carefully to avoid over-blending.
4d. If stopping the machine mid-cycle, use the START/STOP switch, not the POWER
switch. If the POWER switch was used, wait 30 seconds for power to recycle and
the timer to reset before resuming operation.
5. After blender has been turned off, wait until blade comes to a complete stop before
removing the lid or container from the motor base.