Filter
Top Products
8
Blade Agitator Assembly. Blades are sharp; use
caution when handling the blade. When inserting the
blade assembly through the container bottom, align the
flat sides. Gravity holds it in place while the retainer nut
is tightened. Do not attempt to disassemble this part.
Drive Spline. Mates with drive socket on the motor
base to turn the blade. Note: Removing and replacing
your container while the coupling is still rotating will
strip the drive spline “teeth”. (This part is NOT
removable.)
Retainer Nut. Must be snug. Order the available
retainer nut wrench for best results. (Refer to the
diagram below to remove or replace.)
4
8
16
2
4
32
CAUTION: Do not remove blades unless absolutely necessary!
At times, it may be necessary to give your blades additional
cleaning. An easy-to-use blade assembly removal wrench
(Item #15596) may be purchased through your Vita-Mix
distributor.
Never attempt to take the blade assembly itself
apart. This will void the warranty.
Turn the container upside down and grip firmly. Insert retainer
nut wrench in groove of retainer nut and rotate counterclock-
wise to loosen. Then grip blades with a cloth and remove
retainer nut by hand.
Replacing Blade Assembly
With the container upside down, grip blades with cloth, insert
into the container bottom and align with flat sides of container
opening. Place retainer nut on and hand tighten. Last, carefully
turn clockwise until secure, using wrench. Do not force. If it is
not tight enough, you will notice increased container noise.
Blade Assembly Removal
Retainer Nut Wrench
in use.
Retainer Nut Wrench
Never use a blade assembly with loose, damaged or nicked components.